Faller Polar Bear Enclosure 130563

This model has only 34 plastic parts to glue together.
Faller's website gives the wrong dimensions for this model - the dimensions stated on the back of the box are 170 x 186 x 60 mm.
The model extends "below ground" by 30mm (without motor) or 64mm (with motor).

Note the realistic looking green edge on the "glass". The instructions recommend applying a green marker pen
along the bottom edge of each clear plastic piece. In the above photo, the bottom piece has yet to be coloured.

The Polar Bear is glued onto a small piece of clear plastic film. A magnet is glued between the paws.
A corresponding magnet is glued to a disc that is attached to the motor.


Back to Amusement Park Home Page